Dental Laboratory Milling Supplies Core Dental Ceramics ST 16 Pre -
ST COLOR block: suitable for single shaded crown and bridge with
VITA classic 16
|ZZ CAD/CAM|| ||D95-10|
3-4 units bridge
5-6 units bridge
Bridges over 7 units
1 .Place a zirconia block in your CAD/CAM machine and machine it
following the manufacturer’s instructions.
2 .After machining is completed, remove the zirconia block from the
CAD/CAM machine first. Then remove the framework from the zirconia
block with a diamond disc. Subsequently, place the framework on a
sintering tray with zirconia beads and put them in the oven for
3 .Program the furnace according to its instruction manual and
zirconia block’s sintering chart, and then start sintering.
4 .Do not remove the sintered framework until it is fully cooled
down. Examine the sintered framework for wall thickness, margin fit
and seat fit. If necessary, make minor adjustments with a water
cooled diamond tool.
5 .Make sure no wall thickness is less than 0.5mm and no connector
is thinner than 9mm2.
6 .Rinse the sintered framework with water and dry completely.