Zirconium Oxide Ceramic , Dental Zirconia Sintering Pre-Sintered
Zirconia Discs Zirconium
3-4 units bridge
5-6 units bridge
Bridges over 7 units
Used for dental restoration using different CAD/CAM or manual
milling machines. All Blanks are processed through dental
laboratories or by dental professionals.
Instruction for use:
1 . Fix the zirconia blank in the specific clamping device.
2 . Start the milling process.
3 . Remove milledcrown or bridge from blank and pre-trim with
4 . Remove the dust fromthe crown or bridge with air gun.
5 . Color the crown or bridge with coloring liquid, Final-dry frame
under infrared lamp (see manual for coloring liquid).
6 . Load into furnace.
7 . Select sintering program and start sintering(see sinter
8 . Remove sintered crown or bridge from furnace after the furnace
temp drop to room temperature.
9 . Check crown or bridge on working model for sitting and margin
fit. Trim with grinder and polisher if required.
10 . Clean with brush using water. Do not steam-clean.
11 . Choose glaze to finish the restoration.
12 . Now the restoration is ready for the try-in.